Calibration Service
YUDEN-TECH CO., LTD. Calibration Laboratory is accredited by the Taiwan Accreditation Foundation (TAF) under Accreditation No. 3032. The laboratory provides calibration services in accordance with ISO/IEC 17025:2017 and within its accredited scope, covering six calibration categories : temperature, humidity, dew point, air velocity, flow, and pressure. These services support the metrological traceability of measurement results and help address equipment management, process monitoring, and quality management requirements.
I
YUDEN-TECH CO., LTD. Calibration Laboratory has established a management system and calibration procedures in accordance with ISO/IEC 17025:2017 requirements and performs measurement uncertainty evaluations. Within its TAF-accredited scope, the laboratory provides calibration services for temperature, humidity, dew point, air velocity, flow, and pressure instruments. Calibration results are metrologically traceable and can serve as references for equipment management and quality control.
YUDEN-TECH CO., LTD Calibration Laboratory
ilac-MRA, TAF (ISO/IEC 17025) Certification (Certification number: 3032)
It provides accurate calibration services through TAF on behalf of Internationally recognized grade standards and can be traced back to the SI unit.
Accredited capabilities list
| Project | Scope of Accreditation |
|---|---|
| Resistance thermometer | -40°C ... +300°C |
| Hygrometer | Temperature:0°C ... 69.5°C Humidity:10% ... 95% |
| Dew point transmitter | ≧-80°C ... ≦60°C |
| Air velocity transmitter | 0.2 m/s ... 60 m/s |
| Flow transmitter | Water flow rate:2.54 ... 30 m³/h (42.3 ... 500.0 L/min) Water flow velocity:0.2 m/s ... 3 m/s |
| Pressure transmitter | Relative pressure:10 kPa ... 7000 kPa Absolute pressure:20 kPa ... 170 kPa |
Calibration System
Calibration service process
Based on the instrument type, measurement range, and calibration requirements, YUDEN-TECH CO., LTD. Calibration Laboratory evaluates the applicable calibration services and acceptance conditions. Before submitting an instrument for calibration, customers are advised to provide the instrument brand, model, measurement range, requested calibration items, calibration points, and any additional requirements. This information helps confirm the available calibration scope, instrument suitability, and subsequent service arrangements. For instruments other than eyc-tech products, an operating manual must also be provided.